Wyse WES2009 2GF/1GR hardware/software Guide d'installation télécharger pdf (Page 9)

Installing Flash and RAM 5

Step 2: Install the Flash Module

Warning

Flash modules may be susceptible to damage by Electro-Static Discharge

(ESD). All industry-standard cautions should be followed to avoid ESD.

Before you remove or install a module, touch any metal part of the chassis

and keep that contact with the chassis during the installation process.

1. Note where the connector of the flash module is located in Figure 4. Remove the

existing flash module from the socket.

Figure 4 Removing the existing flash module

2. Install the new flash module in the reverse order of removing the original flash module

making sure to align the plastic tab of the module’s connector with the notch in the

connector on the board.

Step 3: Install the RAM Module

Warning

RAM modules may be susceptible to damage by Electro-Static Discharge

(ESD). All industry-standard cautions should be followed to avoid ESD.

Before you remove or install a module, touch any metal part of the chassis

and keep that contact with the chassis during the installation process.

1. Note where the connector of the RAM module is located in Figure 5. Remove the

existing RAM module. Use your fingers to unlock the two retaining clips at either side of

the RAM module by pushing in the direction of the arrows shown in Figure 5. The

module should pop up from its socket. Lift out the RAM module.

Figure 5 Removing the existing RAM module

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Pas de commentaire

Wyse WES2009 2GF/1GR hardware/software Guide d'installation Page 9