Wyse V30LE Guide d'installation télécharger pdf (Page 8)

4 Chapter 2

Figure 2 Wyse Simple Imager console

3. Select V12 in the Select Product list, and then click Add to open the Add Image dialog

box.

Figure 3 Add Image dialog box

4. Use the following guidelines:

• Product - V12 is automatically entered (leave this value).

• Image Version - Enter Conversion for Image Version. This refers to the new

Firmware version.

• Flash Size - This is the amount of flash memory installed in your cloud client. Flash

Size can be 128, 256, 512, 1024, 2048.

NOTE: To determine the flash size of your cloud client (location of the flash size is

as follows):

·V30LE: Start > Control Panel > System > System Info tab

·V50LE: Start > Control Panel > System > System Information > Identity tab

·V90LE and V90LEW: Start > Control Panel > System > Client Information >

General tab

Tip

See your cloud client documentation for help on viewing the flash size.

• Description - Enter what you want for your information. This information will help

you identify the characteristics of the device for which you are using this image.

IMPORTANT: Be sure to use only Alphanumeric characters (A through Z and 0

through 9), underscore (_), or spaces.

• Image File - Click Browse, navigate to the folder on your hard drive that contains

the 1V12.i2d file (this is the location you selected in "Step 2: Copy the 1V12 Folder

and 1V12.i2d File (on the DVD-ROM) to Correct Locations"), click on the 1V12.i2d

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Wyse V30LE Guide d'installation Page 8