Wyse 1GF/1GR upgrade kit Guide d'installation télécharger pdf (Page 11)

5. To remove the existing flash module, depending on the type of module you have, you

must either pull up the module in the direction as shown in

Figure 7, or remove the two

screws as shown in Figure 8. Rock the module carefully until free of the connector.

Warning

Flash and RAM modules may be susceptible to damage by Electro-Static

Discharge (ESD). All industry-standard cautions should be followed to avoid

ESD. Before you remove or install a modules, touch any metal part of the

chassis and keep that contact with the chassis during the installation

process.

Figure 7 Removing an older-type flash module

Figure 8 Removing screws from newer-type flash module

6. Install the new flash module in the reverse order of removing the old module.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Wyse 1GF/1GR upgrade kit Guide d'installation Page 11